Friday, 25 January 2013

NASA Clipper Duet Depth Transducer, Part 1

Click-Click-Click !  That’s the sound of a new depth transducer working – the most beautiful sound we’ve heard in a long time !  With the bad luck we’ve had lately, we fully expected the worst.

The new depth transducer.
Having little experience with these creatures, here’s what I learned after calling NASA Marine Instruments in both England and France (who, curiously, provided exactly the same advice).

1.  Re-initialize the system to its default settings if you think the problem may be in the instrument rather than just the transducer head.  How to do this is not provided in the instruction manual, so here it is:  (NOTE:  this will reset your total trip log to ZERO !)
  • With power off, hold down and press the TOTAL key and the ILLUM key simultaneously.
  • Turn the power on
  • Continue to hold about 4 seconds, then release both buttons simultaneously.
  • The display should read ALL SET, then LOA.  It has now been reinitialized. 

2.  Put your ear to the transducer and listen for the clicks.  If it is not clicking, the transducer is not working.  Hurdle number 1: borrow or buy a new transducer, plug it into the display unit and listen for clicking.  If you do hear clicking, you aren’t out of the woods yet.  You need to verify that the display unit is also functioning.  You can check the display unit by rubbing the palm of your hand on the transducer (as if polishing it).  The OUT should change to random numbers.  This is where we declared victory earlier today.

In our joy, we went ahead and pulled out the old transducer cable and passed the new one in its place.  Our next challenge is to figure out how to (gently?) remove the old transducer from the through-hull fitting without damaging the through-hull support that we would like to reuse.   

The through-hull assembly we hope to re-use.
After studying this at home, I realized that the black screw cap has to be slid onto the cable of the new transducer BEFORE passing the cable through the boat to the display unit.  Merde ! Oh well… it wasn’t a difficult path and we’ll just have to take it out and re-pass it after putting the cap on.  On to the next hurdle.    


2 comments:

Shark Safari said...

Thanx! Your advice saved us a lot of stress.

Sailing Mareda said...

Thanks Shark Safari ! I hope it helped.